Tubular

Threaded eyelet with jaws for NPTF conical thread (it is a sealing NPT thread without the need to use Teflon tape / glue, etc.) Size: according to the selected variant Ascent: according to the chosen variant Thread taper: 16 Material: HSS - high-speed steel Standard: ASME B1. 20.3 Usage: soft structural steels up to 500 N/mm2, automatic steels, structural steels and refined steels with a strength of up to 800 N/mm2, copper alloys, alloyed aluminum Adjustable design - by tightening the screws in the shaft, it is possible to adjust the diameter of the resulting thread. If you do not overstretch the screws in the beam and tighten only so that the jaw does not fall out of the beam, it works like an ordinary round jaw with a full profile.

Threaded dies with jaws / threaded jaws Thread type: R or also Rc or BSPT (British Standard Pipe Taper) - tubular inch thread with conical profile Conicity: 1:16 Climb: in numbers of turns per inch Top angle: 55 ° Material: HSS - High speed steel Dimensions - see attached catalog sheet Standard: ISO-7/1, DIN 24230 Usage: Well machinable materials up to 800 N / mm2 Non-alloy and low-alloy steels

Circular adjustable dies Thread type: R or also Rc or BSPT (British Standard Pipe Taper) - tubular inch thread with conical profile Conicity: 1:16 Pitch : in numbers of turns per inch Top angle: 55 ° Form: A Material: HSS - High speed steel Dimensions - see attached catalog sheet Standard: DIN 2999, DIN 382 Usage: Well machinable materials up to 800 N / mm2 Non-alloy and low-alloy steels

Hexagon thread die / thread die with hexagon jaws Thread type: R or also Rc or BSPT (British Standard Pipe Taper) - tubular inch thread with conical profile Conicity: 1:16 Pitch : in numbers of turns per inch Top angle: 55 ° Form: A Material: HSS - High speed steel Dimensions - see attached catalog sheet Standard: DIN 2999, DIN 382 Usage: Well machinable materials up to 800 N / mm2 Non-alloy and low-alloy steels

Steel conduit thread die Material: CS - Carbon tool Steel Standard: ČSN EN 22 568 / DIN40430 CS dies are suitable for thread stretching or for piece thread cutting

Steel conduit thread die Material: HSS - High Speed Steel Standard: ČSN EN 22 568 / DIN40430 for piece thread cutting

Steel conduit thread die with spiral point / chip breaker Material: HSS - High Speed Steel Standard: ČSN EN 22 568 / DIN40430 for piece thread cutting

Threaded eye with jaws / Threaded eye with jaws Size R 1/4 "(BSPT / Rc 1/4) Rising !N: 19 z / 1 " Pipe thread Outer diameter of the eye: 38mm Standard: Ä ENSN EN 24 231 Corresponds to such © standard 22 3210 Material: NO - Tool Steel Not used from oversupply

Thread eye with jaw / threaded eye with jaws BSPT Pubular thread conical right Size: R 5/8" Pitch: Taper: 1:16 Ape angle: 55° Outer eye diameter: 55mm Standard: ISO-7/1, DIN 24230 Material: NO - tool steel Use: Well machinable materials up to 600 N/mm2 Non-ferrous metals