Special calipers

Professional calliper / slide / slide with depth gauge with data output with replaceable contacts Scope: according to the selected variant Division: 0.01mm Protection IP54 : Protection against dust, protected against splashing water Four buttons. Measurement with absolute zero. Extra fine movement, precisely ground sliding bar. Unlimited feed rate. Czech instructions attached. Battery : CR2032 (3V) Each of these scales meets the accuracy of DIN862 It is possible to issue a calibration protocol for each of these scales! A USB cable for connecting to a PC can be purchased with the scale (see attached photos), order code: 6040.9

Slide gauge for pipes - for measuring pipe thickness Measurement range: according to the selected variant Resolution: 0.01 mm Height of the jaws: 30mm (measured from the circular touch clamp down) ABS function With data output Without depth gauge

Digital universal slider, data output Possibility to measure in inches or millimeters. Measurement range: 24-224mm Material: stainless steel / INOX Automatic shut-off for longer inactivity Battery: CR2032 There are 3 sets of round interchangeable pushrods (see enclosed photo). Additional buttons 7321, 7381, 7391 and 7392 can be purchased for the slider - see attached photo, further stop at measurement at given depth 6143 additional touch - see enclosed catalog sheet

Digital caliper for measuring radii / diameters of incomplete circles / parts Measurement range: 0-150mm Splitting: 0,01mm Battery: 1,5V, type SR44 < The measured value is the radius of the measured part. The measured part must touch the scale arms - see attached photo! Data output RS 232 Also suitable for measurements in inaccessible places and wherever it is not possible to measure the diameter eg partially encapsulated parts.

Digital caliper for measuring radii / diameters of incomplete circles / parts Measurement range: 0-200mm Splitting: 0,01mm Battery: 1,5V, type SR44 < The measured value is the radius of the measured part. The measured part must touch the scale arms - see attached photo! Data output RS 232 Also suitable for measurements in inaccessible places and wherever it is not possible to measure the diameter eg partially encapsulated parts.

Measurement range: 0-150mm Resolution: 0.01 mm Height of jaws: 30mm (measured from the ring clamp down) Round Diameter: 4mm Without Depth Gauge

Measuring range: 0-150mm 0.01mm < br> Battery: 1.5V, SR44 type Data output RS 232