Metalworking tools

Usage: External edges inner side of tube Suitable for brass and cast iron

Usage: External Edge Sheets Inside and Outside tubes - ojehluje both edges at one time Suitable for steel, aluminum and copper

Accelerator, tube and plate deburring machine. With non-replaceable blade. Set of bracket and two different Ojhlovací knives. The total length of the bracket (without the tip) is 120 mm. Holder is all-metal. One piece knife, type E, part of the package

Tube and Tube Dehumidifier Set of bracket and two different O-rings. The total length of the holder (without the tip) is 130mm. Holder is all-metal. One piece knife, type E, part of the package

Centering pin for carbide drill HAND Diameter: 6,35mm Length: 123mm

Weldon clamp holder 3/4 "(19,05mm) for carbide drill HAND Clamping shank: weldon 3/4" Clamping thread: M18x6 P1.5(thread M18x1 .5 with six-helix)

Carbide core drill / twist / carbide drill bit MBL, without shank, without center drill Diameter: 42 mm Max. drilling depth steel / stainless steel: 20.0mm Max. drilling depth in soft metals / non-ferrous metals: 28.0 mm Max. drilling depth in hand drill: 6mm in steel Tooth width: 4mm Clamping thread: M18x6 P1,5(thread M18x1, 5 with six-helix) Clamping shank: not included(see related products) Center drill: not included(see related products)) It has tensioned carbide teeth, which allow easier drilling with less compression force. The drill must not be overheated, otherwise the carbide blades will fly off. We recommend using drills with a diameter of more than 65 mm only in a column drill with clamping over Morse taper. Application: * Steel with strength up to 900MPa * Steel with strength up to 1100MPa * Steel with strength up to 1300MPa * Cast iron * Stainless steel and titanium alloys * Aluminum, brass, bronze, plastics

Holder with cylindrical shank for carbide drill RUKO Clamping shank: cylindrical with three flats Center drill: 6, 0 mm x 72mm, HSSCo5(Order No. 113216) Clamping thread: M18x6 P1.5(thread M18x1.5 with six-screw)

Morse shank holders for carbide drill RUKO Clamping shank: morse taper 2 Centering drill: 6.0 mm x 72mm, HSSCo5(obj. No. 113216) Clamping thread: M18x6 P1,5(thread M18x1,5 with six-helix)

Centering drill bits for core crusher HAND Diameter: 6,0 mm Total length: 72mm Material: HSSCo5 Suitable for stopwatches 113201 and 113203

Holder, mandrel for clamping bimetallic crowns with a diameter of 14-30mm Drill diameter: 6.5mm Hexagon for clamping: 11mm For clamping drill bits diameter 14-30mm Thread: UNF 1/2 "x 20 feet per inch The holder is including HSSE Co5 drills Type: A1

Holder, mandrel for clamping bimetallic crowns with diameters of 32-210mm Drill diameter: 6.5mm Hexagon for clamping: 11mm For clamping drill bits diameter 32-210mm Thread : UNF 5/8 "x 18 go per inch The holder is including HSSE Co5 drills Type: A2