Quick couplings and terminals
-
Quick couplings and mandrels
-
Hose nipples
-
Threaded reduction
-
Threaded couplings
-
Connecting nuts - sleeves
-
Knees with external thread
-
T-pieces with external thread
-
T-pieces with internal thread
-
Distributors
-
Plugs, blinds
-
Tire filler caps
-
Hose couplings
-
Flow and safety valves
-
Drain valves
-
Seals
-
Safety pressure relief valve 1/4 "G, adjustable 8-12bar, red
Valve can be set to 8 to 12 bar pressure The pressure / pressure relief valve serves as a fuse against exceeding the maximum pressure in the reservoir CAUTION - does not replace the pressure switch! Fittings: 1/4 "G with 8mm length Hexagon: 14mm (inside 10mm) Pressure release can also be manually wrapped around a ring that is connected to a sealing cone < The valve can be adjusted to a lower opening pressure - procedure: Removing the ring (key ring), removing the red plastic cap Using the 10 and 14mm wrenches, the lock nut is released. Pressure air pressure to the pressure at which the safety valve should be opened 10mm sensibly allow the valve insert until the valve releases and the pressure leak Tighten the key # 14. Press the pressure in the reservoir and re-press Observe the data on the pressure gauge and check the value at which it opens this safety valve If necessary fine-tune the procedure as described above.
In stock4,24 € with VAT -
Safety safety pressure relief valve 1/4 "G, 10bar
Safety valve with seal - 10bar / atm Function: At higher pressure in the distribution, the pressure that the spring develops on the ball inside the valve is overcome. This will open, respectively. bounce the ball and release the hole - on the photo. This valve should only serve as a secondary overpressure protection - ie if an electric or mechanical control valve fails.
In stock7,36 € with VAT -
Set of adapters for tire fillers
Set of 3 adapters with thread M8x0,75 - Conical nozzle for inflatable water lounges, M8x0,75 End caps have an external clamping thread. a fuse that is commonly used with tire fillers Alternatively, in the corner end with a lever, which is also on offer.
In stock4,01 € with VAT -
Mandrel with 1/2 "G female thread for quick coupling - steel
1/2 "threaded quick connect coupling G 1/2" female thread This SE4 and SE8 Series couplings are compatible with steel, steel, silver surface Diameter of the mandrel is 11.9mm, thread depth 13mm Overall length 36mm Outer shear hexagon has a dimension of 25mm Lumber of the mandrel is 6.8mm
In stock2,17 € with VAT -
Mandrel with internal thread 3/8 "G for quick coupling
3/8 "G Threaded Coupling Thread G 3/8" Female Thread This SE4 and SE8 Series Couplings are compatible with brass, material: brass, gold surface Diameter of the mandrel is 11.9mm, thread depth 11mm Overall length 34mm External hexagon socket 19mm
In stock1,45 € with VAT -
Quick coupling with female thread 3/8 "G
Quick release coupling, 3/8 "G female thread Quick Coupling is compatible with SE8 and SE4 Series Quick Couplings and Clamps 12mm Thick Plug Internal Connector 3/8 "G thread has a depth of 13mm Overall length 42mm Tightening bolt 21mm
In stock2,43 € with VAT