Marking and labeling

Replacement tip for pneumatic engraving pen The tip is ground to the tip in the range: 0.2mm to 0.3mm Wide range of options use, from glass to steel up to 63HRC The tip is made of high quality tungsten carbide. Disassembly is easy, the tip can be reground.

Spare hose including ends for GION GP-940 engraving pen

Needle diameter: 3mm Overall length: 160m

Drawing needle with carbide tip Total length: 150mm

Drawing needle with replaceable carbide tip Total length: 150mm

Replacement tip for creasing needle Kmitex 3025.4

Hardcover tip for ARKOGRAF A25 / 3 and A50 / 6

Hardcover tip for ARKOGRAF A25 / 3 and A50 / 6

Hardcover tip for ARKOGRAF A25 / 3 and A50 / 6

Hardcover tip for ARKOGRAF A25 / 3 and A50 / 6

The tip is of high quality, made of tungsten carbide.

This type of marking of metal parts does not burden the impact with the marked surface. Allows you to highlight all types of logos, graphics, numbers, pictures, codes and other high quality information. Marking is done due to a chemical reaction that causes surface breakage of the metal. The reaction is induced by the simultaneous action of the electrolyte solution and the el. current. Required characters are highlighted through special types of transparencies. Supplied in original plastic case. This type of EC 100 is very cost-effective and includes basic controls for professional marking of metal surfaces without the need for a stroke or other physical effort.