Manual and pneumatic lubrication presses

Classic lubrication press with steel container with filling and venting valve and decompression screw Can be used for loose grease and cartridges. There is an air valve on the body of the head to facilitate the build-up of pressure after filling Working pressure: 20MPa Dosage quantity: 0.95 cm3 Thread for lubrication hoses: M10x1,0 Container diameter: 57mm Total length: 370mm

Red plastic cap for manual lubricators

ZR-1 lubricating pneumatic press comes with 2 terminals. May be used for fat free in cartridges. When the compressed air is connected, the operating pressure is 2-10 Atp Hydraulic gear 80-200 Atp

Classic lubrication press with push-in tip. Two hoses with collet end are also included Can only be used on loose grease. Thread for lubrication hoses: NPT 1/8 "(possibly it is possible to cut to thread G 1/8") Magazine length: 28cm Magazine diameter: 6cm

Lubricating press for manual and pneumatic control. The package includes a mechanical and pneumatic pump, a rigid and flexible attachment with 2 quick couplings heads. You can use both cartouche and fat for free. When compressed air is connected, the operating pressure is 2-10 Atp. Hydraulic transmission 80-200 Atp. The design of the tube allows both cartridges and fill grease to be used as a cartridge. After filling and releasing the push-button, press the air valve to air the system and prepare for pressure lubrication. Thread for hoses: NPT 1/8 "

ZR-Z2 extension set for hand and pneumatic lubrication presses - end caps for wide use

Classic lubrication press with push cubes. There are two end caps. Lubricant can also be used on the cartridge. The head of the head is an air vent valve that facilitates the build-up of pressure after filling

500ml Classic lubrication press with push cushions. There are two end caps. Lubricant can also be used on the cartridge. -