Two-arm puller, for set KN 107710S

Internal Bearing Puller (without Adapters), suitable for KN 107710 for Bearing Removal

This puller can be used directly with adapters 34-58mm (see photo). For downloading 8-34mm diameter, you need to buy threaded reduction - see "Recommended accessories" or related products

Pendulum lenght: 135mm
Pads: 10x16mm

Rotary nut with hexagon 24mm , in which a M10 male thread is screwed into the M16x1,25 thread.

Application:

Application:

< br> The pivoting arms of the high strength steel puller are finished with support plates. In the middle of the fork, the nut that is passed through the screw is rotatably mounted. On the top side, the screw is ended with a hexagon.
There is a thread inside the bolt at the bottom.
The clamp that is firmly tightened in the bearing ring rotates the screw together with the puller.
Subsequent rotation of the nut occurs while holding the bolt to pull the adapter and pull the bearing out of the bed.

Operating Instructions: - See enclosed photos and videos

Recommended accessories:
1. Thread reduction M10 - M12 (male thread) to clamp adapters 8-34mm to puller