Pneumatic tap M12-M22 with adjustable arm, VAT-1622

Air tapping head / tap Range: according to the chosen variant Size of TC extensions: according to the selected variant Speed: see label for each variant Min. compressor power: 5HP (corresponds to 3.8kW) Required pressure: 6-7 bar Air consumption: 940 l / min The tapping head works at a pressure of 6-7 bar, the inlet air must be dry and clean. Regularly add suitable pneumatic oil to the lubricator container. Use suitable cutting oil when threading. After one hour of operation, allow the head to cool for 10-15 minutes. Clean and inspect the head at 3-month intervals. Before each thread cutting, check that the machined surface is parallel to the tapping arm (correct threading in the axis). The tap is without tap adapters, available for purchase - see related products

Quick release attachment / sleeve / insert / collet TC820 / GT20 with slip for machine taps The attachment clamps taps: DIN 371 (reinforced shank): see attached table DIN 376 (classic shank): see attached table Method of clamping the tap: The taps are secured in the extension by a square and a clamping shank. The tap is firmly held in the extension, it is pulled out after pressing the clamping collar in the front of the extension. Features : The tap is clamped in a suitable collet TC820, which has a torque coupling already preset, or it can be fine-tuned as needed. This insert fits into a thread cutter - see related products. Cannot be used alone.