90° HSS blade for needler 01-091 with undercut 20°, KOPAL

Machine chuck for inner edges / machine needle Range: 3-41mm Bevel angle: 90 Â ° Number of runs: 1(run is rotating - ie for two uses) Clamping shank: morse 2 / MK2 The coaster is delivered without running â „c itu , these can be purchased with a sharp angle: a) 14 Â °(cat. No. 01-350), suitable for special bronze, plexiglass b) 20 Â °(cat. no. 01-358), suitable for ordinary steel, steel, plastics, stainless steel c) 25 Â °(cat. no. 01-359), suitable for aluminum, iron, sheets Needle dimensions: Total length: 165mm Front diameter Parts: 42mm Diameter of aluminum nuts: 65mm and 60mm Shank length: 78mm Blade insertion procedure and height adjustment deburring / chamfering 1) Loosen the worms on the body of the trimmer(in the milled groove). 2) Insert the body into the body, secure it with two worms. 3) Adjust the chamfer height by tightening / loosening the aluminum nut. 4) Make sure that the runner is not drowned in the body of the needler, if so, rearrange the aluminum nut and check so that the runner protrudes. 5) Always tighten the aluminum nuts with the sprocket.