NPT NPTF

Circular thread dies Thread type: NPT (National Pipe Thread) - American tubular inch thread with conical profile Conicity: 1:16 Pitch: in numbers of turns per inch Top angle: 60 ° Material: HSS - High speed steel Dimensions - see attached catalog sheet Standard: ANSI / ASME B1.20.1. , DIN24230 Usage: mild structural steels up to 500 N / mm2, free-cutting steels, structural steels and heat-treated steels up to 800 N / mm2, copper alloys, aluminum alloy

Circular thread dies Thread type: NPT (National Pipe Thread) - American tubular inch thread with conical profile Conicity: 1:16 Pitch: in numbers of turns per inch Top angle: 60 ° Material: HSS - High speed steel Dimensions - see attached catalog sheet Standard: ANSI / ASME B1.20.1. , DIN24230 Usage: mild structural steels up to 500 N / mm2, free-cutting steels, structural steels and heat-treated steels up to 800 N / mm2, copper alloys, aluminum alloy

Threaded eyelet with jaws for NPTF conical thread (it is a sealing NPT thread without the need to use Teflon tape / glue, etc.) Size: according to the selected variant Ascent: according to the chosen variant Thread taper: 16 Material: HSS - high-speed steel Standard: ASME B1. 20.3 Usage: soft structural steels up to 500 N/mm2, automatic steels, structural steels and refined steels with a strength of up to 800 N/mm2, copper alloys, alloyed aluminum Adjustable design - by tightening the screws in the shaft, it is possible to adjust the diameter of the resulting thread. If you do not overstretch the screws in the beam and tighten only so that the jaw does not fall out of the beam, it works like an ordinary round jaw with a full profile.